How to Measure a Torsion SpringHow to Measure a Torsion Spring
What is a High Cycle Spring?What is a High Cycle Spring?

Commercial / Industrial Torsion Springs 3 3/8" ID to 6" ID

Overhead Door Parts
ALL COMMERICAL INSDUSTRIAL TORSION SPRINGS ARE MADE TO YOUR SPECIFICATIONS. ALL SPRING SALES ARE FINAL.

FOR PRICE QUOTE CALL 1 800 829 6002
EMAIL:info@overheaddoorparts.com


Manufactured from the highest quality spring steel available.



PLEASE HAVE THE FOLLOWING INFORMATION
  • #1 Wire Size
  • #2 Inside Diameter
  • #3 Length of spring
  • #4 Wind of spring (Right or left wound)

WIRE SIZE
A springís wire size can be determined by several different tools or techniques. Use of a caliper, micrometer, or wire gauge are common ways to determine a springís wire size. If none of these tools are available, simply measure ten coils of wire to the nearest 1/16th of an inch, and refer to the Spring Wire Chart. The spring must be tightly compressed, with no gaps. Itís also a good idea to measure twenty coils as a double check.

INSIDE DIAMETER
Measure the inside diameter to the nearest 1/16th of an inch. In most cases, the cones inserted in each end of the spring will have a manufacturers name (OHD or Raynor, etc.) which will give a clue toward the proper identity. The chart on the right shows common IDís used by various manufacturers. If no manufacturers name is evident, usually a part number on the cone will indicate the inside diameter:

134 or 175 = 1 3/4" ID

258 or 263 = 2 5/8" ID

375 or 334 = 3 3/4" ID



LENGTH OF SPRING
Measure spring length with the spring coil to coil(not including the end caps) in its unwound state. In the case of a distorted or broken spring, simply count the total number of coils and multiply by the wire size.

120 coils x .250 wire = 30"

120 coils x .375 wire = 45"


 

RIGHT OR LEFT HAND WOUND
To ensure the correct wind, please refer to the Winding Chart below. Please remember the side of the door a spring is located on does not indicate the wind of the spring. Most winding cones are color coded for hand identification. Right hand wound springs should have red winding cones. Left hand wound springs should have black winding cones.
Left Hand Wound
Right Hand Wound